Simocode pro v programming manual

Description > Simocode pro v programming manual

Click on link to DOWNLOAD: ※ Simocode pro v programming manual - Link

This setting is the default and the one which is normally used. Depending on the size of the contactor, the main contacts can switch several hundred amps while the auxiliary contacts are only rated for control currents of a few amps. Control stations and inputs of the control function e.

This setting can be modified during operation. This means that many startups can be performed in a short space of time. Range: 0 to 15 default: 0.

Siemens Cable for use with SIMOCODE-DP Series - A notice warning of injury to persons with a safety alert symbol may also include a warning relating to property damage. The tripping class can be modified during operation.

If products and components from other manufacturers pro used, these must be recommended or approved by Siemens. Proper manual, storage, installation, assembly, commissioning, operation and maintenance are required to ensure that the products operate safely and without any problems. Customer is responsible to prevent unauthorized access to its plants, systems, machines ;rogramming networks. Every function block has a name and can be equipped with inputs and outputs. The inputs and outputs are used for the internal connection of the various function blocks and, thus, the setup of a device-internal logic instead of an externally wired logic in the control circuit. The trip class can be set to eight different settings, ranging from Class 5 to Class 40. Thus, the tripping time can be adapted precisely to the power-up behavior of the motor, improving utilization of the motor capacity. Merely replacing the measuring module hardware does not change the tripping behavior. This means that many startups can be performed in a short space of time. For a 1- phase type of load, the internal ground-fault monitoring and the unbalance protection must be deactivated. Phase programming Simocode is manuak automatically. If no setting is made, there will be no response. Setting range: 0 to 25. In this case, for example, the motor can be shut down independently of the overload protection. The remote switching operation should be controlled via the bus. The key-operated switch operation has priority programjing all other operating modes. The amount of usable status information is directly dependent on the selected control function. These can be flexibly adapted and expanded. Control stations and inputs of the control function e. The typical change-over time from star to delta is between 100 ms and 150 ms. The current setting I 1 or I 2 must be converted according to the secondary currents of the external transformers. For more information, see Chapter Overload protection Page 34.